[ GPS sensor ]

Device battery sensor

Charge or voltage of the internal battery of the tracker. Shown as a level and used for low-battery alerts.

Device battery

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “Device battery”.
  2. Pick the parameter the device sends for it, for example battery.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Ways to read it ]

  • Value sent by the devicetag_value
  • Between a minimum and a maximummin_max_values
  • With a formulaformula

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Bit extractionbitcut
  • Formulaformula
  • Value mappingmapping
  • Min / max rangeminmax
  • Unitunit

[ Device data it uses ]

  • Battery voltagebattery
  • Battery levelbatteryLevel
  • Low batteryalarm

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]