[ GPS sensor ]

VIN sensor

Vehicle identification number, read from OBD or the CAN bus.

VIN

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “VIN”.
  2. Pick the parameter the device sends for it, for example vin.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Sensor options in TrackeraX ]

  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • ASCII decodingascii
  • Bit extractionbitcut
  • Value mappingmapping
  • Text extractionsetflag
  • Ignore empty valuesskip_empty

[ Device data it uses ]

  • VINvin

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]