[ GPS sensor ]

Temperature sensor

Temperature from 1-Wire or BLE probes, the engine coolant or the device itself. Useful for the cold chain: charts, history and alerts when it leaves the range.

Temperature

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “Temperature”.
  2. Pick the parameter the device sends for it, for example deviceTemp.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Calibration tablecalibration
  • Formulaformula
  • Ignore empty valuesskip_empty
  • Unitunit

[ Device data it uses ]

  • Device temperaturedeviceTemp
  • Coolant temperaturecoolantTemp
  • Engine temperatureengineTemp
  • Temperature sensors (temp1, temp2…)
  • Temperaturealarm

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]