RPM sensor
Engine revolutions per minute from OBD or the CAN bus. Useful for driving behaviour and high-RPM alerts.

[ How to set it up in TrackeraX ]
- Open the device in TrackeraX and add a sensor of type “RPM”.
- Pick the parameter the device sends for it, for example rpm.
- Adjust the options below (unit, formula, calibration…) and save.
- The value shows on the map, in history, charts and reports, and you can use it in alerts.
[ Sensor options in TrackeraX ]
- Chartsadd_to_graph
- Historyadd_to_history
- Map widgetadd_to_widgets
- Formulaformula
- Ignore empty valuesskip_empty
- Unitunit
[ Device data it uses ]
- RPMrpm
- High RPMalarm
[ GPS protocols that send this data ]
Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.
- gt06249 models
- teltonika182 models
- gl200146 models
- jt808105 models
- suntech101 models
- meiligao71 models
- meitrack59 models
- t800x46 models
- atrack43 models
- navis39 models
- ruptela35 models
- castel31 models
- galileo31 models
- totem31 models
- gps10329 models
- alematics26 models
- taip26 models
- startek16 models
- intellitrac14 models
- iotm13 models
- huasheng12 models
- bce11 models
- aplicom10 models
- bstpl10 models
- omnicomm9 models
- arnavi7 models
- easytrack7 models
- starcom7 models
- freematics6 models
- fox4 models
- thuraya4 models
- flespi3 models
- jmak3 models
- owntracks3 models
- tytan3 models
- flexapi2 models
- leafspy2 models
- pacifictrack2 models
- plugin2 models
- radshid2 models
- easytrackplus1 models
- gt06qze1 models
- naviset1 models
- pricol1 models
- ruptela21 models
- sprint3x1 models
- suntech21 models
- teltonika21 models

