Engine block sensor
Shows whether the engine is blocked by the relay of the device, the same one you control with the engine stop and resume commands.

[ How to set it up in TrackeraX ]
- Open the device in TrackeraX and add a sensor of type “Engine block”.
- Pick the parameter the device sends for it, for example blocked.
- Adjust the options below (unit, formula, calibration…) and save.
- The value shows on the map, in history, charts and reports, and you can use it in alerts.
[ Sensor options in TrackeraX ]
- Chartsadd_to_graph
- Historyadd_to_history
- Map widgetadd_to_widgets
- Bit extractionbitcut
- On / off valueslogic_on
[ Device data it uses ]
- Blockedblocked
[ GPS protocols that send this data ]
Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.
- gt06249 models
- h02124 models
- jt808105 models
- eelink37 models
- tk10333 models
- jt60030 models
- trv14 models
- bstpl10 models
- easytrack7 models
- mobilogix6 models
- g2004 models
- milesmate3 models
- radar3 models
- jido2 models
- omnijq2 models
- pst2 models
- sigfox2 models
- easytrackplus1 models
- gt06qze1 models
- icar1 models
- maxitrac1 models
- sprint3x1 models
- xrb281 models

