[ GPS sensor ]

Load / weight sensor

Cargo weight from axle-load sensors or a scale connected to the device, with formula and calibration.

Load / weight

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “Load / weight”.
  2. Pick the parameter the device sends for it, for example axleWeight.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Calibration tablecalibration
  • Formulaformula
  • Ignore empty valuesskip_empty
  • Unitunit

[ Device data it uses ]

  • Axle weightaxleWeight

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]