[ GPS sensor ]

External power sensor

Voltage of the vehicle battery or power supply. Detects disconnections, power cuts and low voltage.

External power

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “External power”.
  2. Pick the parameter the device sends for it, for example power.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Ways to read it ]

  • Value sent by the devicetag_value
  • Between a minimum and a maximummin_max_values
  • With a formulaformula

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Bit extractionbitcut
  • Formulaformula
  • Value mappingmapping
  • Min / max rangeminmax
  • Unitunit

[ Device data it uses ]

  • External powerpower
  • Power cutalarm
  • Low poweralarm

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]