[ GPS sensor ]

GSM signal sensor

Mobile signal strength reported by the device, shown as a level between a minimum and a maximum. Helps find coverage problems.

GSM signal

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “GSM signal”.
  2. Pick the parameter the device sends for it, for example rssi.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Min / max rangeminmax

[ Device data it uses ]

  • GSM signalrssi

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]