Engine hours sensor
Engine running time: sent by the device, counted from an on/off input or calculated by the platform. Used for maintenance by hours.

[ How to set it up in TrackeraX ]
- Open the device in TrackeraX and add a sensor of type “Engine hours”.
- Pick the parameter the device sends for it, for example hours.
- Adjust the options below (unit, formula, calibration…) and save.
- The value shows on the map, in history, charts and reports, and you can use it in alerts.
[ Ways to read it ]
- Counter sent by the deviceconnected
- From an on/off inputlogical
- Calculated by the platformvirtual
[ Sensor options in TrackeraX ]
- Chartsadd_to_graph
- Historyadd_to_history
- Map widgetadd_to_widgets
- Formulaformula
- Use as ignitionignition_detector
- On / off valueslogic_on
- Ignore empty valuesskip_empty
[ Device data it uses ]
- Engine hourshours
[ GPS protocols that send this data ]
Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.
- gt06249 models
- gl200146 models
- suntech101 models
- meitrack59 models
- dmt49 models
- atrack43 models
- gosafe42 models
- upro40 models
- navis39 models
- xirgo31 models
- gps10329 models
- taip26 models
- mta620 models
- astra19 models
- fifotrack17 models
- starlink17 models
- startek16 models
- mxt15 models
- iotm13 models
- huasheng12 models
- bce11 models
- aplicom10 models
- arnavi7 models
- easytrack7 models
- t622iridium5 models
- jmak3 models
- owntracks3 models
- pacifictrack2 models
- radshid2 models
- uux2 models
- vtfms2 models
- bws1 models
- continental1 models
- easytrackplus1 models
- gt06qze1 models
- naviset1 models
- sprint3x1 models
- suntech21 models

