Harsh acceleration sensor
Harsh-acceleration event detected by the accelerometer of the device. Counts in driving-behaviour reports.

[ How to set it up in TrackeraX ]
- Open the device in TrackeraX and add a sensor of type “Harsh acceleration”.
- Pick the parameter the device sends for it, for example hardAcceleration.
- Adjust the options below (unit, formula, calibration…) and save.
- The value shows on the map, in history, charts and reports, and you can use it in alerts.
[ Sensor options in TrackeraX ]
- Chartsadd_to_graph
- Historyadd_to_history
- Map widgetadd_to_widgets
- Bit extractionbitcut
- On / off valueslogic_on
[ Device data it uses ]
- Harsh accelerationalarm
[ GPS protocols that send this data ]
Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.
- gt06249 models
- teltonika182 models
- gl200146 models
- jt808105 models
- suntech101 models
- meiligao71 models
- meitrack59 models
- dmt49 models
- t800x46 models
- atrack43 models
- upro40 models
- ruptela35 models
- tk10333 models
- castel31 models
- totem31 models
- xirgo31 models
- taip26 models
- khd25 models
- fifotrack17 models
- l10016 models
- startek16 models
- pt50214 models
- huasheng12 models
- hyn60012 models
- bstpl10 models
- gator8 models
- easytrack7 models
- ivt4015 models
- thuraya4 models
- flespi3 models
- its3 models
- jmak3 models
- owntracks3 models
- nyitech2 models
- plugin2 models
- vtfms2 models
- bws1 models
- easytrackplus1 models
- gt06qze1 models
- its21 models
- ruptela21 models
- sprint3x1 models
- suntech21 models
- teltonika21 models
- transync1 models
- tzone1 models

