[ GPS sensor ]

Odometer sensor

Mileage sent by the device or the vehicle (OBD/CAN), or calculated by the platform from GPS distance. Used in reports and service intervals.

Odometer

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “Odometer”.
  2. Pick the parameter the device sends for it, for example odometer.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Ways to read it ]

  • Odometer sent by the deviceconnected_odometer
  • Calculated from GPS distancevirtual_odometer

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Formulaformula
  • Unitunit

[ Device data it uses ]

  • Odometerodometer
  • OBD odometerobdOdometer
  • Total distancetotalDistance
  • Service odometerserviceOdometer
  • Trip odometertripOdometer

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]