[ GPS sensor ]

Harsh braking sensor

Harsh-braking event detected by the accelerometer of the device. Counts in driving-behaviour reports.

Harsh braking

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “Harsh braking”.
  2. Pick the parameter the device sends for it, for example hardBraking.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Sensor options in TrackeraX ]

  • Chartsadd_to_graph
  • Historyadd_to_history
  • Map widgetadd_to_widgets
  • Bit extractionbitcut
  • On / off valueslogic_on

[ Device data it uses ]

  • Harsh brakingalarm

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]