Charger connected sensor
Shows whether the device is connected to power or charging. Typical of personal and battery trackers.

[ How to set it up in TrackeraX ]
- Open the device in TrackeraX and add a sensor of type “Charger connected”.
- Pick the parameter the device sends for it, for example charge.
- Adjust the options below (unit, formula, calibration…) and save.
- The value shows on the map, in history, charts and reports, and you can use it in alerts.
[ Sensor options in TrackeraX ]
- Chartsadd_to_graph
- Historyadd_to_history
- Map widgetadd_to_widgets
- Bit extractionbitcut
- On / off valueslogic_on
[ Device data it uses ]
- Chargingcharge
[ GPS protocols that send this data ]
Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.
- gt06249 models
- gl200146 models
- jt808105 models
- eelink37 models
- ruptela35 models
- tk10333 models
- megastek31 models
- totem31 models
- xirgo31 models
- jt60030 models
- gps10329 models
- taip26 models
- minifinder21 models
- aquila16 models
- cellocator16 models
- l10016 models
- startek16 models
- xexun216 models
- globalsat15 models
- mxt15 models
- trv14 models
- minifinder211 models
- sanav11 models
- topin11 models
- tramigo11 models
- bstpl10 models
- anytrek7 models
- osmand7 models
- mobilogix6 models
- disha5 models
- globalstar4 models
- robotrack4 models
- visiontek4 models
- xexun34 models
- flespi3 models
- its3 models
- milesmate3 models
- radar3 models
- blackkite2 models
- gpsmta2 models
- jido2 models
- leafspy2 models
- maestro2 models
- navigil2 models
- omnijq2 models
- radshid2 models
- rftrack2 models
- sabertek2 models
- smartcar2 models
- stl0602 models
- swiftech2 models
- techtocruz2 models
- vlt2 models
- vtfms2 models
- auro1 models
- gt06qze1 models
- its21 models
- maxitrac1 models
- ruptela21 models
- sprint3x1 models
- xt0131 models
- xt71 models

