[ GPS sensor ]

Counter sensor

Pulse counter on a digital input: passengers, cycles, liters or any event the device counts.

Counter

[ How to set it up in TrackeraX ]

  1. Open the device in TrackeraX and add a sensor of type “Counter”.
  2. Pick the parameter the device sends for it, for example count1.
  3. Adjust the options below (unit, formula, calibration…) and save.
  4. The value shows on the map, in history, charts and reports, and you can use it in alerts.

[ Sensor options in TrackeraX ]

  • On / off valueslogic_on

[ Device data it uses ]

  • Counters (count1, count2…)

[ GPS protocols that send this data ]

Protocols whose decoder delivers the data above. Each device sends it only if its firmware and installation allow it.

[ All sensors ]